KANKOL 625g

Application Instructions

Joint preparation
The joint surfaces must be clean, dry and free from all contamination. The surfaces should be degreased using the appropriate cleaner. Primers may be required on some substrates.

Insertion of Backup Materials
A suitable material is closed cell, medium density, cross linked Polyethylene foam, strip or rod. Ensure constant and correct depth of joint.

Masking Tape Application
Masking Tape should be used on both sides of the joint to improve the neatness of the finished seal.

Priming
Apply thin film of kankol porous primer on both sides of the joint with a brush. Allow flash-off of solvent before application of sealant ie surface should be touch-dry.

Mixing
The base and curing agent ratio controls the adhesion, strength and durability of Kankol 625G. The base and curing agent must therefore be thoroughly

mixed. Finishing
Finishing can be done by using soap solution. Tooling sealant surface with soap solution wetted finger.

Tooling
Depth Gauge may be used to recess sealant as specified in the drawing.

Cleaning After sealing the joint the tools and equipments should be cleaned immediately with kerosene or any other cleaning solvents/thinners.

Packaging

KANKOL 625P KANKOL POROUS PRIMER KANKOL NONPOROUS PRIMER
1 KG (approx. 625 ML) 250 ML 250 ML
 

GUIDE TO KANKOL 625G QUANTITIES

Joint Size in mm Kg/meter run Meter Run/4kg pack
5 X5 0.040 100
10 X 5 0.080 50
10 x 10 0.160 25
20 x 10 0.320 12.50
40 x 20 1.28 3.12

Health and Safety
Avoid prolonged contact with skin. If sealant comes into contact with the eyes, flush with cold water and obtain medical attention.

Storage Life
12 months in original unopened packaging stored in a cool, dry place out of direct sunlight

Technical Support
KANGARU provides technical advisory service supported by teams of specialists in the field.