Quality Assurance
Being a quality-centric organization, we ensure that the products get delivered at clients' end after proper their checking on various parameters. Moreover, we ensure these products are manufactured using premium quality raw material and in compliance with the international quality standards. These Poly Containers are known for their durability, cost effectiveness and high performance. We also test our products on regular basis that helped us in delivering a wide range of premium quality range to our clients.
Our products are tested for quality on the following parameters:
| Test | Procedure |
|---|---|
| Stacking Test | A container is filled and is kept under filled containers for 48 hours |
| Closure Leakage Test | A container is filled with water and tightened with the cap and is kept upside down on the floor for a minimum 2 hrs |
| Drop Test | As per the ISI Standards, we check the containers for this test with help of a drop test, wherein we drop containers every four hours from a height of 1.2 meters |
| Weight | We check these drums for electronic welding for weighing of each drum |
| Melt Flow Test | We conduct our procedure starts right from raw material itself as we test each lot of raw material |
| Pin-hole Test | A bulb/torch, light is inserted in the mouth of container to check for foreign particles/ pinholes |
| Handle Strength | Drum is filled with material was kept one + 2 to ensure to see total pressure on the drum kept on the surface |
| Wall Thickness | Our containers are inspected by infrared light there and detecting the portion of the infrared light which passes through the container and converts the same into corresponding electrical signals, which are delivered to a microprocessor. The microprocessor stored information and compares the electrical signals regarding desired wall thickness of the container and then, emits output thickness information. |
| Print Adhesive | We test the adhesion of ink to the container surface |