Shreepad Industries

Dial Indicator Stand

This tool is useful for testing spindle run out of machine tools, lathe work etc. It is well adapted for inspection of the parallelism of surfaces. The indicator can be swiveled in all directions. The base is of steel and provided With T slots for convenience in clamping. The surfaces of the base are accurately ground. New clamping System ensures quicker rigid clamping even with moderate tightening. The holder for the Dial Indicator is equipped with fine adjustment device permitting vibration free adjustment to zero.
Specifications:

KM – 300
Length Of Base 250 Mm
Width Of Base 50 Mm
Height Of Base 35 Mm
Height Of Column 225 Mm
Diameter Of Column 18 Mm

Heavy Duty Dial Indicator Stand

This extra heavy and ruggedly made universal testing stand is used wherever the highest accuracy is required in using a comparator. It can be used in many different ways; on the surface plate in testing parallel surfaces of work pieces on machine tools for setting up pieces to be machined with reference to already existing surfaces or for inspecting mounted pieces for run-out etc. The surfaces of the H-formed base, the column and the extension arm are high precision ground. The column can be moved and clamped in any position of the base with a knurled nut. The extension arm, which can be adjusted in height moved lengthwise and swiveled is sufficiently rigid that vibrates during the measurement even with the fullest extension are at a minimum. The base of the indicator stand is made of steel or cast iron.
Specifications:

KM - 301
Height Of Column 300mm 500mm 800m
Maximum Horizontal
Extension 350mm 350mm 350mm
Length Of Base 300mm 300Mm 300mm
Width Of Base 100mm 100mm 100mm
Diameter Of Column 40mm 40mm 40mm
Extension Arm 25mm 25mm 25mm

Lever Type Dial Indicator

RH – AM

RH – BH
CH – CM
DTH – M
KJH – D
RH – B
CH – C
DTH

Rectangular Holder type AM 8 mm*4.8 mm pin diameter 4 mm.
Rectangular Holder Type BM 13 mm*6mm, pin diameter 4 mm.
Cylinder Holder Type CM 9.5 mm diameter, pin diameter 4 mm.
Swivel Clamp with Dovetail Holder (Metric models) Bore diameter 4 – 9.5 mm.
Knuckle Joint Holder (Dovetail).
Rectangular Holder Type A 5 / 16 " * 3 / 16,pin diameter 1 / 4 "
Cylindrical Holder Type C 3 / 8 " diameter pin diameter 1 / 4 ".
Swivel Clamp with Dovetail Holder (Inch models) Bore diameter 1/4–3/8 ".

Complete Set	Specifications Consists Of
Tool post holder	9.5 * 19 * 150
Upright spindle	8 dial * 115 L
Universal Clamp	6.5 and 8 holes
G – Clamp	33 capacity round or flat

Extra contact points With Domed Anvil and Round Anvil Tommy bar. Hole attachment with indicator Mounting hole and swivel Arm 9.5 hole for dial indicator.